谘詢熱線
-->
當前位置: 首頁 > 新聞中心 > 公司動態 >

電動卷簾門安裝方法注意要點

發布人:http://www.levels4life.com    發布時間:2017-01-06 13:25:41

  在安裝電動卷簾門需要注意的事項,你知道嗎?如下為您介紹一下在安裝電動卷簾門的時候需注意的幾個要點:

  In the installation of electric shutter doors need to pay attention to matters, you know? Here are some of the key points you should pay attention to when installing the electric rolling shutter door:

  1、複核洞口與產品尺寸是否相符,防火卷簾門的洞口尺寸,可根據3M。

  1, check the hole and the product size is consistent with the size of the fire door, according to 3M.

  2、確定安裝水平線及垂直線,按設定尺寸依次安裝。槽口尺寸應準確,上 下保持一致,對應槽口應在同一平麵內,然後用連接件與洞口內的預埋件焊牢。

  2, determine the installation of horizontal and vertical lines, according to the size of the installation. The slot size should be accurate, consistent, corresponding grooves shall be in the same plane, and then use the connecting piece and the hole in the welding parts.

  3、卷門機必須按說明書要求安裝。

  3, rolling door machine must be installed according to the specification requirements.

  4、卷軸、文架板必須牢固地裝在混凝土結構上或預埋件上。

  4, the scroll, frame plate must be firmly installed in the concrete structure or embedded parts.

  5、寬大門體需在中間位置加裝中柱,兩邊有滑道。中柱安裝必須與地麵垂 直,安裝牢固,但要拆裝方便。

  5, a door body in the middle position is in the column, slide on both sides. The column installation must be perpendicular to the ground, the installation is firm, but to facilitate disassembly.

  6、門體葉片插入滑道不得少於30 mm,門體寬度偏差為土3 mm。

  6, the door leaf is inserted into the slideway of not less than 30 mm, the door body width deviation of soil is 3 mm.

  7、防火卷簾門水幕係統裝在防護理下麵,噴嘴傾斜15°角。

  7, fire shutter door curtain system installed in the prevention of nursing tilt angle of 15 degrees below the nozzle.

  8、安裝完略,先手動調'自試運行,觀察門體上下運行情況,正常後通電調試。

  8, the installation is slightly, the first manual adjustment 'self test run, observe the door body running up and down, after the normal commissioning.

  9、觀察卷簾機、傳動係統、門體運行情況應啟閉正常、順暢,速度為3-7 米/分鍾。

  9, to observe the rolling machine, transmission system, the door body should open and close the normal, smooth, speed of 3-7 M / min.

  10、調整製動器外殼方向,使環形鏈朝下;調整鏈條張緊度,鏈條6-10 mm;調整單向調節器及限位器。

  10, adjust the direction of the brake shell, so that the chain down; adjust the chain tension, the chain 6-10 mm; adjust the one-way regulator and limit.

  11、卷筒安裝應先找好尺寸,並使卷簡軸保持水平位置。注意與導軌之間的距離應兩端保將一致,臨時固定後進行檢查,並進行必要的調篷、校正,無誤後再與支架預埋件用電焊焊接。

  11, reel installation should first find good size, and make the roll shaft to maintain a horizontal position. The distance between attention and guide should be guaranteed both ends will be consistent, temporary fixation after the inspection, and make necessary corrections, awning, correct with embedded parts by welding welding bracket.

  12、清理、粉刷或鑲砌導軌牆體裝飾麵層,清理現場。

  如有需要,歡迎新老客戶前來選購!向日葵污视频下载本著質優價廉的宗旨來為您提供產品和服務。真誠期待與您合作!

  12, cleaning, painting or inlay guide wall decorative surface, clean up the scene.

  If necessary, welcome new and old customers come to buy! We aim to provide you with quality and cheap products and services. Sincerely look forward to working with you!


上一篇:哪種材質的車庫門更具防盜性能
下一篇:濟南快速卷簾門的特點
產品中心
聯係向日葵视频app下载ioses网站免费