谘詢熱線
-->
當前位置: 首頁 > 新聞中心 > 公司動態 >

為什麽快速卷簾門運行過程中不能關閉?

發布人:http://www.levels4life.com    發布時間:2020-02-25 11:24:00

首先檢查感應控製器:如果感應控製器的綠燈長,則此時自動開關無法操作;必須按下傳感器上的重置按鈕5秒鍾以上。釋放後,紅燈點亮,綠燈熄滅。複位後,如果綠燈仍然亮著,請檢查接地線圈周圍是否有相應的鐵塊。

First check the induction controller: if the green light of the induction controller is long, the automatic switch cannot be operated at this time; the reset button on the sensor must be pressed for more than 5 seconds. When released, the red light is on and the green light is off. After reset, if the green light is still on, please check whether there is corresponding iron block around the grounding coil.20161214807515.jpg


在自動狀態下,如果超過設定時間,門仍不會掉落,請檢查紅外指示器是紅色還是綠色,綠色是正常狀態,紅色表示故障,並且紅外位置已適當調整,直到綠燈亮;無論是門體被卡住還是車門線束被拆卸。

In the automatic state, if the door does not fall after the set time, please check whether the infrared indicator is red or green, green is normal, red indicates failure, and the infrared position has been adjusted properly until the green light is on; whether the door body is stuck or the door harness is removed.

門體的重複操作:當門體出現反複運行時,首先檢查門體在跌落過程中是否有物體或窗簾體本身切斷了紅外條件,並采取相應的措施消除了。如果快速關閉門未關閉,請參考上述方法進行調試。

Repeat operation of the door body: when the door body runs repeatedly, first check whether there is an object or the curtain body itself cuts off the infrared condition during the falling process of the door body, and take corresponding measures to eliminate it. If the quick closing door is not closed, please refer to the above method for debugging.


上一篇:鋼製防火電動卷簾門的運作過程
下一篇:自動車庫門的優越性能體現在哪?
產品中心
聯係向日葵视频色板app免费下载