谘詢熱線
-->
當前位置: 首頁 > 新聞中心 > 行業新聞 >

濟南卷簾門維修需要注意什麽?

發布人:http://www.levels4life.com    發布時間:2019-03-14 11:22:38

伸縮門在維修時,有一些必需要重點留意的中央,這樣才幹到達好的維修效果。下麵為您引見伸縮門維修的一些留意事項:

  When repairing telescopic doors, there are some central points that need to be paid attention to, so as to achieve good maintenance results. Below Wanjiahong expansion door maintenance for you to introduce some cautions of expansion door maintenance:

  1、伸縮門報警功用的性能取決於報警探頭的性能用戶應依據報警的實踐需求選配報警探頭。

  1. The performance of telescopic door alarm function depends on the performance of alarm probe. Users should select alarm probe according to the practical needs of alarm.

  2、伸縮門報警探頭輸出信號接口的類型應為繼電器輸出接口供電電壓應為直流12—15V否則不能由本控製器直接供電,探頭耗電應≤100毫安.依據現場狀況可配用多隻探頭(普通以1――2隻為宜)多探頭時采用並接方式。探頭應防止其他熱源或直射光影響上方應加防雨罩。

  2. The output signal interface type of telescopic door alarm probe should be DC 12-15V. Otherwise, the power supply voltage of the relay output interface should not be directly supplied by the controller. The power consumption of the probe should be less than 100 mA. According to the field conditions, multiple probes (usually 1-2 only) can be used when multiple probes are used. The probe should be protected from other heat sources or direct light, and the rain cover should be above it.

  3、伸縮門自動停機功用可依據用戶的門體行程設置出廠時設定為145秒左右。

  3. The automatic shutdown function of telescopic door can be set to about 145 seconds when it leaves the factory according to the user's door travel.

  4、發現伸縮門開門和關門方向相反時將控製器的"V""W"端子接線對調即可,同樣STOP顯現屏指示方向與實踐相反時按同法調整接線。

  4. It is found that when the opening and closing directions of the telescopic door are opposite, the "V" and "W" terminals of the controller can be aligned. Similarly, when the direction of the STOP display screen is opposite to the practice, the wiring should be adjusted in the same way.

20161214103489.jpg

  5、本控製器發作毛病時應由人員停止維修或與供貨方和消費廠聯絡維修,以免毛病擴展影響運用。

  5. When the controller breaks down, it should be stopped by professionals or liaised with suppliers and consumer factories for maintenance, so as to avoid the expansion of the fault affecting the operation.

  6、伸縮門控製器應堅持清潔避免進水或其他有害物質腐蝕,機殼清潔嚴禁運用有機溶劑。

  6. Controller of telescopic door should insist on cleaning to avoid corrosion of water intake or other harmful substances. It is strictly forbidden to use organic solvents when machine case is clean.

  7、伸縮門的電纜芯數普通不應少於8線門體電纜中間不應含有接頭。

  7. The number of cable cores of telescopic doors should not be less than 8-wire portal cables without joints.

  8、遙控發射器應堅持外殼好避免擠壓振動跌落進水等現象。留意檢查電池電壓必要時及時改換.當遙控間隔過近時普通應改換電池,電池型號為KC12V-23A.遙控器應盡量避開電磁幹擾源。

  8. The remote control launcher should adhere to the shell to avoid the phenomenon of extrusion vibration falling into the water. Take care to check the battery voltage when necessary and change it in time. When the remote control interval is too close, the battery should be changed generally. The battery model is KC12V-23A. The remote controller should avoid electromagnetic interference sources as far as possible.

  9、遙控器出廠時按編碼加密運用不能互換。用戶需求更改時可由廠家按請求變卦密碼。

  9. When the remote controller leaves the factory, it can not be interchanged by encrypting. When user needs change, the manufacturer can change the hexagram password according to the request.


上一篇:卷簾門維修配件的選用!
下一篇:電動車庫門聲音大的原因和處理方法!
產品中心
聯係向日葵视频成年app下载安装