谘詢熱線
-->
當前位置: 首頁 > 新聞中心 > 行業新聞 >

卷簾門的限位怎麽調整?

發布人:http://www.levels4life.com    發布時間:2019-05-30 11:30:11

  很多卷簾門的客戶反映,門落不到底,門抬不到頂,諸如此類。這種情況首先要排除門體導軌和電機傳動機構是否卡死,但經常發生門體不落到底,升不上頂,一般是限位開關位置誤差造成的。

  Many customers of rolling curtain doors reflect that doors can not fall to the bottom, doors can not lift to the top, and so on. In this case, we should first rule out whether the door guide rail and the motor drive mechanism are jammed, but it often happens that the door body does not fall to the bottom and does not rise to the top, which is generally caused by the position error of the limit switch.

  所以對於卷簾門的限位開關究竟如何調整,向日葵视频app下载ioses网站免费首先要介紹一下限位開關的原理。

  So for how to adjust the limit switch of the curtain door, we should first introduce the principle of the limit switch.

  限位開關是一種簡單的開關式傳感器,它是一種開關,用來檢測物體是否已經到達位置。它屬於機械觸發器類。當物體接近限位開關時,它就會觸發。

  Limit switch is a simple switching sensor. It is a switch used to detect whether the object has reached its position. It belongs to the category of mechanical triggers. When an object approaches the limit switch, it triggers.

  那麽卷簾門的限位開關起什麽作用呢?

  So what role does the limit switch of the curtain door play?

  上升或下降的快門由電動機控製,當你按下向上或向下按鈕,電動機根據相應的方向,使它停止的高位和低位限位開關控製,當門運行高限位開關,限位開關觸發電動機停止信號,因此本門停止,或增加快門會使整個快門電動機傳動部件受損,或者銷毀。滾動門運行到低點也是如此。

20161219618477.jpg

  The up or down shutter is controlled by the motor. When you press the up or down button, the motor will stop the high and low limit switch according to the corresponding direction. When the door runs the high limit switch, the limit switch triggers the motor stop signal. Therefore, the stop of the gate or the increase of the shutter will damage or destroy the whole shutter motor drive component. This is also true of rolling doors running to the bottom.

  因此,限位開關在對卷簾門起電路控製的同時也起著至關重要的保護作用。

  Therefore, the limit switch plays an important role in protecting the curtain door circuit.

  調整限位開關的位置更細膩,如果低限製過高,它會顯示,百葉窗不跌至底部的現象,如果高限額太低了,它就會出現,使用百葉窗不達到頂峰的現象。

  Adjusting the position of limit switch is more delicate, if the minimum limit is too high, it will show that the louver does not fall to the bottom of the phenomenon, if the maximum limit is too low, it will appear, the use of louvers does not reach the peak.

  在調節時,先鬆開兩個限位開關的螺絲,然後手動將卷簾門調到低點,當卷簾門剛達到低點時,此時在電機上,將低限位開關調整到剛剛觸發狀態,然後擰緊螺絲。同樣,手動將卷簾門調到高點,當卷簾門剛達到高點時,再在電機上,將高限位開關調整到剛剛觸發狀態,然後擰緊螺絲。

  When adjusting, first loosen the screw of two limit switches, then manually set the shutter door to the lowest point. When the shutter door just reaches the lowest point, at this time, on the motor, adjust the minimum switch to the just triggered state, and then tighten the screw. Similarly, manually adjust the curtain door to the highest point. When the curtain door has just reached the highest point, then on the motor, adjust the maximum limit switch to the just triggered state, and then tighten the screw.

  完成以上步驟後,用按鈕控製、打開、關閉幾次,觀察卷簾門是否達到該位置,重複三次是否正常,宣布調整完畢。

  After completing the above steps, use buttons to control, open and close several times, observe whether the rolling shutter door reaches the position, repeat three times normally, announce that the adjustment is completed.


上一篇:車庫門工業門是怎麽增加門板強度的?
下一篇:從哪些細節來看開門機的質量?
產品中心
聯係向日葵污视频下载