發布人：http://www.levels4life.com 發布時間：2020-01-19 17:58:21
Because the electric roller shutter is composed of end plate, drum, roller shutter motor, chain, guide rail, roller shutter, control cabinet and other components. The push-pull guide rail of the electric rolling shutter must be completed. If the electric shutter is often derailed, it will often appear stuck, which is easy to last Monday or above. If the electronic shutter can be released, it will often appear automatic sliding door, which is easy to cause damage to others. What about the decoupling of the electric rolling shutter?
First, understand several situations caused by decoupling of electric rolling shutter door:
1、 Fracture phenomenon of the axle tube of the electric roller shutter.
2、 The fixing bolts of the fixing base of the electric roller shutter shaft pipe are loose to fix the fixing base down.
3、 Fix the axle tube of the electric roller shutter door and the fixed seat by the net wire, so that the axle tube is fixed and separated.
4、 The blade of the electric louver is detached, or the fixing screw with the shaft tube is loose, which makes the door leaf fall off.
5、 The door is stuck after being pulled, and the knife edge is dislocated.
The fault detection must be overhauled, and the decoupling of electric rolling shutter door shall be solved with special attention:
1. In the process of re installation, pay attention to the integrity of the circuit, standardize the use and installation of roller shutter doors.
2. When using the electric roller shutter, people should pay attention that the track and suspension pulley of the electric roller shutter should not be oiled, otherwise the roller will slide on the hanger, causing the door to collide.
3. When the electric louver is derailed or uncoupled, or a line is not connected to a circuit, or a line is broken, during the loading and unloading process, it is preferred to check the condition of the power circuit, and then check other items later, such as checking that the motor line and the relay power plug fall due to vibration and mechanical failure.