發布人：http://www.levels4life.com 發布時間：2020-03-05 14:38:39
Now the roll up door in Jinan has been basically popularized. People don't pay much attention to the maintenance of the roll up door, which is a very bad phenomenon. The rust proof work of the roll up door of Jinan roll up door manufacturer can't be ignored.
Summer and autumn are rainy seasons in Jinan. We should pay special attention to rust prevention during the use of roller shutter doors. The rusty roller shutter doors in Jinan are not only unsightly in appearance, but also greatly reduce the efficiency when it is convenient to use.
In the process of daily use, metal shutter doors are exposed to the air, which will inevitably be exposed to the sun and wind, so the probability of oxidation is very high.
Because of the relationship between materials, the old metal shutter door installed before is easy to oxidize, rust surface or even destroy the structure of the door body after 2-3 years of use, resulting in the situation that the metal shutter door cannot be used.
Now this problem has attracted enough attention of the rolling shutter manufacturers. Before the new metal rolling shutter leaves the factory, the surface has been specially treated, which can ensure that it will not rust for 3-5 years under normal use.
Therefore, the old type of metal shutter door, once oxidized, indicates that the door body is not far from scrap. At this time, a layer of paint can be sprayed on the surface to delay the oxidation of the metal.
No matter old or new type of metal shutter door, it needs to wipe the dust, rain and other foreign matters adsorbed on it every week to prevent metal oxidation.
In addition, in the process of daily use, it is necessary to avoid collision with the door body, which will cause the metal materials of Jinan roller shutter door to be exposed in the air and shorten the service life.
In order to prevent the iron door from rusting, we can regularly use cotton cloth dipped in a small amount of anti rust oil or sewing oil to wipe the surface part of the roller shutter door. If it is found that the roller shutter door has begun to have rust spots, we should use cotton yarn dipped in engine oil as early as possible to coat the rust spots, so as to remove the rust, instead of directly using sandpaper and other rough materials for grinding.
There are also some chrome plated iron gates that are afraid of gas and oil fume. Therefore, iron gates cannot be installed near gas stoves and coal stoves to prevent gas and oil fume from corroding the chrome plating layer. I hope you will pay more attention to these problems. Because details determine success or failure.